checking the wheel nuts
Monthly Checks
Before you ride – Check: -
- Wheels are tightly secured
- Tyres are inflated to correct pressure (indicated on side wall of tyre) Also check condition of tyres for cuts etc. (Note it is a good idea to carry a puncture repair kit or spare inner tube, tyre levers and pump with you)
- Handlebar stem and headset locknut are tight and the steering turns smoothly.
- Brakes – Squeeze levers to ensure sufficient pressure can be applied without the lever touching the handlebars. Also ensure brake blocks are aligned correctly with rim and the blocks are not badly worn.
- Brake cables are not frayed at the end.
- Gears operate correctly.
- Wheels are running true by spinning them; you can also check that mudguards, if fitted are correctly adjusted at this time.
- Saddle is adjusted to the correct riding position and the seat pin is tightened.
After long or hard rides or at least every month of regular use – Check same points above + the following: -
- Clean, degrease and lubricate your bike
- Cranks, bottom bracket fittings and pedals are tight
- Tyre wear and general condition for cuts, glass, thorns etc
- Spokes are not loose or broken. These need to be attended to before the bike can be ridden again and you would probably need to get these done at your dealer.
- Hubs are running smoothly.